ALL OF THE VENEERS ARE UNFINISHED READY TO FINISH 

PAPER BACK

OUR PAPER BACKED VENEER IS 10MIL THICK.  YOU WOULD APPLY SOLVENT BASED CONTACT CEMENT TO BOTH THE PAPER SIDE OF THE VENEER AND THE SURFACE OF THE ITEM TO BE VENEERED.  THE CONTACT CEMENT IS ALLOWED TO DRY TO THE TOUCH THEN THE VENEER IS PUT IN PLACE AND A ROLLER IS USED TO INSURE FULL CONTACT.  ONCE THE CONTACT CEMENT TOUCHES EACH OTHER THE PIECES CAN NOT BE MOVED 

HOT MELT GLUE BACKED

OUR HOT MELT GLUE AND  VENEER IS ALSO 10MIL THICK AND YOU WOULD USE A CLOTHING IRON TO APPLY THE VENEER. THE IRON SHOULD NOT HAVE ANY WATER AND SET ON A WOOL SETTING.  THE VENEER CAN BE REHEATED AND REMOVED FOR REPOSITIONING  JUST LAY THE GLUE SHEET DOWN ON A FLAT SURFACE WITH THE GLUE UP AND THEN LAY THE VENEER DOWN WITH THE WOOD SIDE UP LIGHTLY IRON THE SURFACE SO THAT THE GLUE ATTACHES TO THE BACK THEN THE PAPER BACK CAN BE REMOVED AND THE VENEER CAN THEN BE APPLIED TO THE SURFACE WITH THE IRON SET ON ABOUT A WOOL SETTING

PEEL AND STICK

OUR PRESSURE SENSITIVE VENEER IS ALSO 10MIL THICK TO INSTALL ALIGN THE VENEER SHEET ON THE SUBSTRATE SURFACE AND PULL BACK 2 INCHES OF THE RELEASE LINER. MAKE CONTACT WITH THE VENEER SHEET SURFACE AND MAKE CERTAIN THE ALIGNMENT IN CORRECT.  SLOWLY PEEL BACK THE RELEASE LINER WHILE APPLYING PRESSURE WITH A WOOD SCRAPER OVER THE ENTIRE AREA